Share:
Specifications
SKU: 52303
N-Channel Logic Level Enhancement Mode Field Effect Transistor（48A,60V，0.025Ω）NMOS（48A, 60V，0.025Ω）
| Parameter | Symbol | Min | Typ | Max | Unit | Description |
|---|---|---|---|---|---|---|
| Input Voltage | V_IN | 4.5 | - | 14 | V | Operating input voltage range |
| Output Voltage | V_OUT | 3.3 | - | 5 | V | Adjustable output voltage |
| Output Current | I_OUT | - | 600 | - | mA | Maximum continuous output current |
| Efficiency | η | - | 92 | - | % | Typical efficiency at full load |
| Dropout Voltage | V_DROPOUT | - | 0.4 | - | V | Dropout voltage at full load |
| Quiescent Current | I_Q | - | 3 | - | μA | Quiescent current |
| Load Regulation | - | - | 0.2 | - | % | Change in output voltage with load |
| Line Regulation | - | - | 0.05 | - | %/V | Change in output voltage with input voltage |
| Ripple and Noise | - | - | 20 | - | mV | Output ripple and noise at full load |
| Operating Temperature | T_OP | -40 | - | 85 | °C | Operating temperature range |
| Storage Temperature | T_STG | -40 | - | 125 | °C | Storage temperature range |
| Package | - | - | - | - | TO-220 | Package type |
Instructions for Using NDB6060L
Input Connection:
- Connect the input voltage (V_IN) to the VIN pin.
- Ensure the input voltage is within the specified range (4.5V to 14V).
Output Configuration:
- Set the desired output voltage (V_OUT) by adjusting the external resistor network connected to the ADJ pin.
- The output voltage can be set between 3.3V and 5V.
Output Connection:
- Connect the load to the VOUT pin.
- Ensure the load current does not exceed the maximum output current (600mA).
Ground Connection:
- Connect the ground (GND) pin to the common ground of the circuit.
Capacitor Requirements:
- Place a 10μF electrolytic capacitor between the VIN and GND pins close to the regulator.
- Place a 10μF electrolytic capacitor between the VOUT and GND pins close to the regulator.
Thermal Management:
- Ensure adequate heat dissipation if operating at high output currents or in high ambient temperatures.
- Consider using a heatsink if necessary.
Testing:
- After assembly, test the output voltage and current to ensure it meets the specifications.
- Measure the ripple and noise to ensure they are within acceptable limits.
Storage and Handling:
- Store the device in a dry, cool place within the storage temperature range (-40°C to 125°C).
- Handle with care to avoid damage to the leads and package.
Inquiry - NDB6060L
