Instructions for Using AD736JR

1. Power Supply:

   • Connect the VCC pin to a power supply between 4.5V and 15V.
   • Connect the GND pin to the ground.

2. Input Signal:

   • Connect the differential input signals to the IN+ and IN- pins.
   • Ensure the input voltage range is within 0V to VCC.

3. Output Signal:

   • The output signal is available at the OUT pin.
   • The output voltage range is from 0V to VCC.

4. Biasing:

   • The input bias current is typically 100nA. Use appropriate biasing resistors if necessary.

5. Calibration:

   • Calibrate the AD736JR to ensure accurate readings. This can be done by applying known input voltages and adjusting the offset and gain settings.

6. Temperature Considerations:

   • The device operates over a temperature range of -40°C to 85°C. Ensure the operating environment is within this range.

7. Package Handling:

   • Handle the 8-lead DIP or SOIC package with care to avoid damage to the pins and internal components.

8. Conversion Time:

   • The conversion time for full-scale input is approximately 20μs. Ensure your system allows for this delay when reading the output.

9. Bandwidth:

   • The full power bandwidth is 100kHz. Ensure that the input signal frequency is within this range for optimal performance.

10. Application Notes:

    • Refer to the datasheet and application notes for more detailed information on specific applications and advanced configurations.