Instructions for Use:

1. Supply Voltage:

   • Ensure the supply voltage (V_CC) is within the range of 4.5V to 16V.
   • Avoid exceeding the maximum supply voltage to prevent damage.

2. Input Bias Current:

   • The input bias current is typically between 20nA and 200nA. Use appropriate input resistors to minimize the effect of this current.

3. Input Offset Current:

   • The input offset current can range from 5nA to 60nA. This should be considered when designing circuits with high gain.

4. Input Offset Voltage:

   • The input offset voltage can vary from 0.1mV to 2mV. Use trimming networks if precise zero offset is required.

5. Input Voltage Range:

   • The input voltage should not exceed V_CC - 1.5V to avoid saturation or damage.

6. Output Short-Circuit:

   • The output can be short-circuited continuously without damage.

7. Slew Rate:

   • The slew rate is typically between 0.5V/μs and 1.5V/μs. This limits the maximum rate of change of the output voltage.

8. Large Signal Bandwidth:

   • For large signals (2V peak-to-peak), the bandwidth is typically between 1MHz and 5MHz.

9. Small Signal Bandwidth:

   • For small signals (20mV peak-to-peak), the bandwidth is typically between 10MHz and 30MHz.

10. Power Consumption:

    • The power consumption is typically around 20mW to 40mW. Ensure adequate heat dissipation if operating at higher power levels.

Additional Notes:

• Always refer to the datasheet for detailed specifications and application notes.
• Proper decoupling capacitors should be used near the power supply pins to ensure stable operation.
• Ensure all connections are secure and free from shorts or open circuits.