Instructions for MCM2018AN35

1. Power Supply:

   • Ensure the supply voltage (VDD) is within the range of 1.7V to 3.6V.
   • Use a stable power source to avoid voltage fluctuations that can affect performance.

2. Temperature Considerations:

   • The device operates reliably between -40°C and 85°C.
   • Store the device between -65°C and 150°C to ensure long-term reliability.

3. Frequency Range:

   • The input frequency (fIN) should be between 1 MHz and 100 MHz.
   • The output frequency (fOUT) will match the input frequency within the same range.

4. Phase Noise:

   • The phase noise at 1 kHz offset from the carrier should not exceed -130 dBc/Hz.
   • At 10 kHz offset, it should not exceed -140 dBc/Hz.
   • At 100 kHz offset, it should not exceed -150 dBc/Hz.

5. Jitter:

   • The typical jitter is 0.5 ps RMS, with a maximum of 1.5 ps RMS.

6. Power Consumption:

   • The device typically consumes 5 mA of current, with a maximum of 10 mA.

7. Output Drive Strength:

   • The output drive strength ranges from 4 mA to 24 mA, providing flexibility for different load conditions.

8. Output Timing:

   • The output rise time (tR) and fall time (tF) are both typically 0.5 ns, with a maximum of 1 ns.
   • The output skew (tSKEW) is typically 0.1 ns, with a maximum of 0.5 ns.

9. Layout and PCB Design:

   • Use short traces for high-frequency signals to minimize signal degradation.
   • Place decoupling capacitors close to the power pins to reduce noise and improve stability.

10. Handling:

    • Handle the device with care to avoid static damage.
    • Follow proper ESD (Electrostatic Discharge) precautions during handling and assembly.

By following these parameters and instructions, you can ensure optimal performance and reliability of the MCM2018AN35.