Share:
Specifications
SKU: 426549
x8SRAM
| Parameter | Description | Value |
|---|---|---|
| Part Number | Device Identifier | HM6116ALP-3 |
| Type | Memory Type | Static Random Access Memory (SRAM) |
| Organization | Memory Organization | 16K x 8 bits |
| Supply Voltage (Vcc) | Operating Supply Voltage | 5.0 V ± 5% |
| Operating Temperature | Temperature Range | -40°C to +85°C |
| Access Time (tAC) | Access Time | 15 ns |
| Cycle Time (tCYC) | Cycle Time | 25 ns |
| Data Hold Time (tDH) | Data Hold Time | 3 ns |
| Data Setup Time (tDS) | Data Setup Time | 10 ns |
| Power Consumption | Active Power Consumption | 300 mW (typical) |
| Standby Current | Standby Current | 10 μA (maximum) |
| Package Type | Package | 28-pin Plastic DIP |
| Pin Configuration | Pin Count | 28 |
| Input Voltage (VIH) | High-Level Input Voltage | 2.0 V to Vcc |
| Input Voltage (VIL) | Low-Level Input Voltage | 0 V to 0.8 V |
| Output Voltage (VOH) | High-Level Output Voltage | Vcc - 0.5 V |
| Output Voltage (VOL) | Low-Level Output Voltage | 0.5 V |
| Write Enable (WE#) | Write Enable Pin | Active Low |
| Chip Enable (CE#) | Chip Enable Pin | Active Low |
| Output Enable (OE#) | Output Enable Pin | Active Low |
Instructions for Use
Power Supply:
- Connect the Vcc pin to a 5.0 V ± 5% power supply.
- Connect the GND pin to ground.
Address Lines:
- Connect the address lines (A0-A13) to the appropriate address signals from your system.
Data Lines:
- Connect the data lines (D0-D7) to the data bus of your system.
Control Signals:
- Write Enable (WE#): Set this pin low to write data to the memory.
- Chip Enable (CE#): Set this pin low to enable the chip.
- Output Enable (OE#): Set this pin low to read data from the memory.
Timing Considerations:
- Ensure that all timing parameters (access time, cycle time, setup and hold times) are met to avoid data corruption.
- Use appropriate pull-up or pull-down resistors on control lines if necessary.
Handling:
- Handle the device with care to avoid static damage.
- Store the device in an anti-static bag when not in use.
Testing:
- Verify the functionality of the device by writing and reading data to and from various memory locations.
- Use a logic analyzer or oscilloscope to verify signal integrity and timing.
Mounting:
- Ensure proper alignment of the device during soldering to avoid damage to the pins.
- Follow the recommended PCB layout guidelines for optimal performance.
Inquiry - HM6116ALP-3
