Instructions for Use

1. Power Supply:

   • Ensure that the supply voltage (Vcc) is within the specified range of 4.5V to 5.5V.
   • Connect Vcc to the appropriate pin and ground (GND) to another pin.

2. Addressing:

   • Apply the desired address to the address lines (A0-A15) to select the memory location.
   • Address lines should be stable before the access time (tAA) begins.

3. Data Read:

   • To read data, apply the address and ensure the chip select (CS) and output enable (OE) pins are low.
   • Data will be available on the data lines (D0-D7) after the access time (tAA).

4. Data Write:

   • To write data, apply the address and data to the appropriate lines.
   • Set the chip select (CS), write enable (WE), and output enable (OE) pins as required.
   • The write cycle time (tWC) must be observed to ensure the data is properly written.

5. Standby Mode:

   • To enter standby mode, set the chip select (CS) pin high.
   • This reduces power consumption to the standby current level.

6. Temperature Considerations:

   • Ensure the device operates within the specified temperature range (-40°C to +85°C) to avoid damage or data corruption.

7. Handling Precautions:

   • Handle the device with care to avoid static discharge, which can damage the internal circuitry.
   • Use proper ESD protection when handling the device.

Pin Diagram