Share:
Specifications
SKU: 572750
Core / Cpu Used = -- ;; External Memory = -- ;; Speed = --, 6, 8, 10, 20 ;; I/O = -- ;; Timers = -- ;; Communications Controller = -- ;; Other Features = -- ;;
| Parameter | Description | Value |
|---|---|---|
| Part Number | Component Identifier | Z84C0008PEC |
| Type | Device Type | CMOS 8-bit Microcontroller |
| Architecture | CPU Architecture | Z80-compatible |
| Clock Frequency | Operating Clock Speed | 0 to 10 MHz |
| Supply Voltage | Vcc Range | 2.7 to 5.5 V |
| Operating Temperature | Temperature Range | -40°C to +85°C |
| Package | Housing Type | 40-pin PDIP (Plastic Dual In-line Package) |
| I/O Ports | Number of I/O Pins | 32 |
| RAM | On-chip RAM Size | 256 bytes |
| ROM | On-chip ROM Size | 8 KB (EPROM) |
| Timer/Counters | Number of Timers/Counters | 2 x 16-bit |
| Interrupts | Number of Interrupt Sources | 13 |
| Serial Communication | UART Support | Yes |
| Watchdog Timer | Watchdog Timer Availability | Yes |
| Power Consumption | Typical Power Consumption at 5V, 4MHz | 100 mW |
Instructions for Use:
Power Supply:
- Connect the Vcc pin to the positive supply voltage (2.7 to 5.5 V).
- Connect the GND pin to the ground.
Clock Configuration:
- Connect an external crystal or oscillator to the XTAL1 and XTAL2 pins for clock generation.
- Alternatively, use an external clock source connected to the XTAL1 pin.
Reset Circuit:
- Ensure a reset circuit is connected to the RESET pin. A typical reset circuit includes a capacitor and resistor to provide a clean reset signal.
Programming:
- Program the on-chip EPROM using a compatible programmer. Follow the programming specifications provided by the manufacturer.
I/O Configuration:
- Configure the I/O ports as inputs or outputs using the appropriate register settings.
- Use pull-up or pull-down resistors as needed for input pins.
Timer/Counter Setup:
- Initialize the timer/counters using the control registers.
- Set the prescaler and mode of operation as required.
Interrupt Handling:
- Enable interrupts by setting the appropriate bits in the interrupt enable register.
- Write interrupt service routines (ISRs) to handle specific interrupt sources.
Serial Communication:
- Configure the UART for serial communication by setting the baud rate and other parameters.
- Use the TX and RX pins for data transmission and reception.
Watchdog Timer:
- Enable the watchdog timer to prevent system lockup.
- Clear the watchdog timer periodically to prevent a reset.
Low Power Modes:
- Use the low power modes (e.g., idle, stop) to reduce power consumption when not actively processing data.
For detailed technical specifications and additional information, refer to the datasheet provided by the manufacturer.
(For reference only)Inquiry - Z84C0008PEC
