Instructions for Use:

1. Handling:

   • Handle the C824G with care to avoid mechanical damage.
   • Avoid touching the ceramic body directly; use the leads for handling.

2. Soldering:

   • Preheat the board to 100°C to 125°C before soldering.
   • Use a soldering iron with a temperature setting of 350°C to 400°C.
   • Solder each lead for no more than 3 seconds to prevent thermal shock.
   • Allow the capacitor to cool naturally after soldering.

3. Mounting:

   • Ensure the leads are bent at a 90-degree angle to fit through the PCB holes.
   • Insert the leads through the designated holes on the PCB.
   • Trim the leads to a length of approximately 1.5 mm after soldering.

4. Storage:

   • Store the C824G in a dry, cool place away from direct sunlight.
   • Keep the components in their original packaging until ready for use.

5. Testing:

   • Use a capacitance meter to verify the capacitance value after installation.
   • Ensure the voltage rating is not exceeded during testing and operation.

6. Disposal:

   • Follow local regulations for the disposal of electronic components.
   • Recycle or dispose of the C824G in an environmentally responsible manner.