Instructions for Using SSM2165-2

1. Supply Voltage:

   • Ensure the supply voltage (VCC) is within the specified range of 4.5V to 5.5V.
   • Connect the VCC pin to the positive supply and GND pin to the ground.

2. Input Connection:

   • Connect the differential inputs (IN+ and IN-) to your signal source.
   • Ensure the input impedance of 10kΩ is considered when designing the input circuit.

3. Output Connection:

   • Connect the output (OUT) to the load or next stage in the signal chain.
   • The output impedance of 100Ω should be considered for proper load matching.

4. Gain Setting:

   • The gain can be adjusted using external resistors. Refer to the datasheet for specific resistor values and configurations.

5. Powering Up:

   • Apply power to the device after all connections are made.
   • Monitor the supply current to ensure it is within the typical value of 1.5mA per channel.

6. Thermal Management:

   • Ensure adequate heat dissipation if operating at high temperatures.
   • Keep the operating temperature within the range of -40°C to 85°C.

7. Signal Integrity:

   • To minimize distortion and noise, use shielded cables and keep signal paths as short as possible.
   • Ensure the signal-to-noise ratio (SNR) and total harmonic distortion (THD) meet the application requirements.

8. Storage and Handling:

   • Store the device in a dry environment within the storage temperature range of -65°C to 150°C.
   • Handle with care to avoid damage to the pins and internal components.

9. Testing:

   • Before finalizing the design, test the device under various conditions to ensure it meets performance specifications.
   • Use a signal generator and oscilloscope to verify the output signal quality and stability.