Instructions

1. Power Supply:

   • Ensure the supply voltage is within the specified range of 2.7V to 5.5V.
   • Connect VCC to the positive power supply and GND to the ground.

2. Signal Connections:

   • Connect the address lines (A0-A13) to the microcontroller or other control logic.
   • Connect the data lines (D0-D7) to the microcontroller or other data bus.
   • Connect the chip select (CS), output enable (OE), and write enable (WE) pins to the appropriate control signals from the microcontroller.

3. Operation Modes:

   • Read Operation:
     • Set CS low to select the device.
     • Set OE low to enable data output.
     • Apply the desired address to the address lines.
     • The data at the addressed location will appear on the data lines after the access time.
   • Write Operation:
     • Set CS low to select the device.
     • Set WE low to enable writing.
     • Apply the desired address to the address lines.
     • Apply the data to be written to the data lines.
     • The data will be written to the addressed location after the access time.

4. Standby Mode:

   • To enter standby mode, set CS high.
   • In standby mode, the device consumes minimal current (1 μA max).

5. Temperature Considerations:

   • Ensure the operating temperature remains within the specified range of -40°C to 85°C to avoid damage or malfunction.

6. Handling:

   • Handle the device with care to avoid static discharge, which can damage the internal circuits.
   • Use proper anti-static measures when handling and storing the device.