Instructions for Use:

1. Supply Voltage:

   • Ensure the supply voltage is within the range of -16V to +16V.
   • The device can operate with a single or dual supply.

2. Input Voltage:

   • The input voltage should be within the range of -14V to +14V relative to ground.
   • Avoid exceeding these limits to prevent damage to the device.

3. Output Voltage Swing:

   • The output voltage swing is typically -13V to +13V under no load conditions.
   • Load resistance will affect the actual output swing.

4. Output Current:

   • The maximum continuous output current is ±10mA.
   • Exceeding this limit may cause the device to overheat or fail.

5. Input Bias and Offset Currents:

   • The input bias current and input offset current are very low, typically within ±50nA and ±10nA, respectively.
   • These parameters are important for high-impedance applications.

6. Input Offset Voltage:

   • The input offset voltage is typically within ±2mV.
   • This parameter affects the accuracy of the amplifier in precision applications.

7. Common-Mode Rejection Ratio (CMRR):

   • The CMRR is high, typically between 80dB and 100dB at 0.1Hz.
   • This indicates good rejection of common-mode signals.

8. Power Supply Rejection Ratio (PSRR):

   • The PSRR is also high, typically between 80dB and 100dB at 0.1Hz.
   • This helps maintain stable output even with power supply variations.

9. Slew Rate:

   • The slew rate is typically 0.5V/μs.
   • This parameter is important for high-frequency applications.

10. Bandwidth:

    • The bandwidth is typically 1.5MHz for a 1V peak-to-peak output.
    • Higher output levels will reduce the bandwidth.

11. Quiescent Current:

    • The quiescent current is typically 2mA at ±15V supply.
    • This is the current drawn by the device when it is not driving any load.

Additional Notes:

• Stability:
  • Use appropriate feedback networks to ensure stability, especially at higher frequencies.
• Temperature:
  • The device is designed to operate over a wide temperature range, but performance parameters may vary.
• Handling:
  • Handle the device with care to avoid static damage. Use proper ESD protection during handling and installation.