Instructions for Use:

1. Power Supply:

   • Connect the Vcc pin to a stable power supply within the range of 2.7 V to 3.6 V.
   • Ensure the ground (GND) pin is connected to the system ground.

2. Addressing:

   • Use the address lines (A0-A22) to specify the memory location you want to read from or write to.

3. Data I/O:

   • The data lines (D0-D7) are used for data input and output. Ensure they are connected to the data bus of your system.

4. Control Signals:

   • Chip Select (CS#): Active low signal to enable the device.
   • Output Enable (OE#): Active low signal to enable data output.
   • Write Enable (WE#): Active low signal to initiate a write operation.
   • Write Protect (WP#): Active low signal to prevent accidental writes.

5. Programming:

   • To program a page, set the CS# and WE# signals low, and provide the appropriate address and data on the address and data lines.
   • Wait for the specified write time (250 μs typical) before initiating another operation.

6. Erasing:

   • To erase a block, set the CS# and WE# signals low, and provide the appropriate erase command and block address.
   • Wait for the specified erase time (1.5 ms typical) before initiating another operation.

7. Reading:

   • To read data, set the CS# and OE# signals low, and provide the appropriate address on the address lines.
   • The data will be available on the data lines after the access time (70 ns typical).

8. Endurance and Data Retention:

   • The device is rated for a minimum of 100,000 write/erase cycles and can retain data for at least 10 years under specified conditions.

9. Temperature Considerations:

   • Ensure the operating temperature is within the range of -40°C to +85°C to maintain reliable performance.

10. Handling:

    • Handle the device with care to avoid damage. Follow ESD (Electrostatic Discharge) precautions to prevent damage from static electricity.

For detailed timing diagrams and specific commands, refer to the datasheet provided by the manufacturer.