Instructions for Use

1. Handling and Storage:

   • Store the CY10E474-5DC in a dry, cool environment to prevent moisture damage.
   • Handle with care to avoid mechanical stress on the leads and body.

2. Soldering:

   • Use a temperature-controlled soldering iron or reflow oven.
   • Soldering temperature should not exceed 260°C for more than 10 seconds.
   • Avoid excessive thermal shock during soldering.

3. Mounting:

   • Ensure the PCB is clean and free from contaminants before mounting.
   • Align the component correctly on the PCB and ensure all leads are in contact with the pads.
   • Apply a consistent and even amount of solder to each lead.

4. Testing:

   • After soldering, visually inspect the component for any solder bridges or misalignments.
   • Use a multimeter to check for proper connectivity and resistance values.
   • Test the capacitance value using a capacitance meter to ensure it falls within the specified tolerance.

5. Operation:

   • Ensure the operating voltage does not exceed the maximum rated voltage.
   • Monitor the temperature to ensure it stays within the specified operating range.
   • If used in high-frequency applications, consider the dissipation factor to minimize losses.

6. Disposal:

   • Dispose of the component in accordance with local environmental regulations.
   • Recycle where possible to reduce waste and environmental impact.