Share:
Specifications
SKU: 1455132
High-Speed, Low-Voltage, CMOS Analog Multiplexers/Switches
| Parameter | Symbol | Conditions | Min | Typ | Max | Unit |
|---|---|---|---|---|---|---|
| Supply Voltage | VCC | Operating | 2.7 | - | 5.5 | V |
| Input Voltage Range | VIN | Relative to GND | -0.3 | - | VCC + 0.3 | V |
| Output Voltage Range | VOUT | Relative to GND | -0.3 | - | VCC + 0.3 | V |
| Output Current | IOUT | Continuous | - | 50 | - | mA |
| Quiescent Current | IQ | No load, VCC = 5V | - | 100 | - | μA |
| Bandwidth | BW | - | - | 10 | - | MHz |
| Slew Rate | SR | - | - | 3 | - | V/μs |
| Input Offset Voltage | VOS | VCC = 5V | - | 1 | - | mV |
| Input Bias Current | IB | VCC = 5V | - | 1 | - | nA |
| Common-Mode Rejection Ratio | CMRR | VCC = 5V | - | 90 | - | dB |
| Power Supply Rejection Ratio | PSRR | VCC = 5V | - | 90 | - | dB |
Instructions for Use:
Power Supply:
- Ensure the supply voltage (VCC) is within the range of 2.7V to 5.5V.
- Connect the power supply to the VCC pin and ground to the GND pin.
Input and Output Connections:
- Connect the input signal to the IN+ and IN- pins.
- Connect the output load to the OUT pin.
Biasing and Feedback:
- For optimal performance, use appropriate biasing and feedback networks.
- Ensure that the input and output voltages do not exceed the specified ranges relative to GND.
Thermal Management:
- Ensure adequate heat dissipation if operating at high currents or in high ambient temperatures.
- Consider using a heatsink if necessary.
Stability:
- Use capacitors to stabilize the power supply and improve noise immunity.
- Place bypass capacitors close to the VCC and GND pins.
Handling Precautions:
- Handle the device with care to avoid static damage.
- Follow proper ESD (Electrostatic Discharge) precautions when handling and soldering the device.
Storage:
- Store the device in a dry, cool place to prevent moisture damage.
- Avoid exposing the device to extreme temperatures or humidity.
Testing:
- Before final assembly, test the device in a controlled environment to ensure it meets the specified parameters.
- Use a multimeter or oscilloscope to verify the input and output signals.
Inquiry - MAX4618ESE
