Share:
Specifications
SKU: 1536285
GLASS PASSIVATED SINGLE-PHASE BRIDGE RECTIFIER
| Parameter | Value | Description |
|---|---|---|
| Part Number | DB105G | - |
| Type | Diode Bridge | Rectifier for AC to DC conversion |
| Maximum Repetitive Peak Inverse Voltage (VRRM) | 1000V | Maximum voltage that can be repeatedly applied in reverse direction without breakdown |
| Maximum RMS Input Voltage (VRMS) | 700V | Maximum RMS input voltage for continuous operation |
| Maximum Average Forward Rectified Output Current (IOAV) | 5A | Maximum average current that can flow through the diode in forward direction |
| Maximum Non-Repetitive Peak Surge Current (IFSM) | 400A | Maximum surge current that can be handled for a short duration |
| Operating Temperature Range (TJ) | -65°C to +150°C | Temperature range for reliable operation |
| Storage Temperature Range (TS) | -65°C to +150°C | Temperature range for storage |
| Junction-to-Case Thermal Resistance (RθJC) | 1.2°C/W | Thermal resistance from junction to case |
| Package Type | TO-220-4L | Standard 4-lead through-hole package |
| Lead Pitch | 2.54mm | Distance between adjacent leads |
| Weight | 2.5g | Approximate weight of the component |
Instructions:
-
Mounting:
- Ensure the diode bridge is mounted on a heat sink if operating at high currents to maintain junction temperature within the specified range.
- Use a thermal compound between the diode and the heat sink to improve thermal conductivity.
-
Soldering:
- Preheat the PCB to 100°C to 150°C before soldering.
- Soldering temperature should not exceed 300°C.
- Soldering time should not exceed 10 seconds per lead.
-
Electrical Connections:
- Connect the AC input to the two center terminals (pins 2 and 3).
- Connect the positive output to the anode terminal (pin 1).
- Connect the negative output to the cathode terminal (pin 4).
-
Handling:
- Handle with care to avoid mechanical stress on the leads and body.
- Store in a dry place away from direct sunlight and extreme temperatures.
-
Testing:
- Test the diode bridge using a multimeter set to the diode test mode to ensure proper functionality.
- Check for continuity between the appropriate pins as per the pin configuration.
-
Safety:
- Ensure the diode bridge is properly insulated to prevent electrical shock.
- Use appropriate fuses or circuit breakers to protect against overcurrent conditions.
Inquiry - DB105G
