Below is the parameter table and instructions for the CXD9936TN, a CMOS image sensor signal processor IC.

CXD9936TN Parameter Table

CXD9936TN Instructions

1. Power Supply:

   • Ensure that the supply voltage (VDD) is within the specified range of 2.7V to 3.6V.
   • Use a stable power source with low noise to avoid affecting the performance of the IC.

2. Temperature Considerations:

   • The operating temperature range is from -40°C to 85°C. Ensure that the IC is not exposed to temperatures outside this range during operation.
   • The storage temperature range is from -65°C to 150°C. Store the IC in a dry and cool environment when not in use.

3. Digital Inputs and Outputs:

   • All digital inputs (VIN) should be within the range of 0V to VDD.
   • Digital outputs (VOUT) will swing between 0V and VDD.

4. Clock Frequency:

   • The maximum clock frequency (fCLK) supported is 133 MHz, with a typical value of 100 MHz.
   • Ensure that the clock signal is clean and stable to avoid data corruption.

5. Power Consumption:

   • In active mode, the typical power consumption (IDD) is 300 mA, with a maximum of 400 mA.
   • In standby mode, the typical power consumption (IDD_STBY) is 10 μA, with a maximum of 20 μA.

6. Data Interface:

   • The CXD9936TN supports both I2C and SPI interfaces for communication.
   • Configure the interface according to the system requirements and ensure proper initialization.

7. Image Sensor Interface:

   • The IC can interface with both MIPI and parallel image sensors.
   • Ensure that the sensor is properly connected and configured for optimal performance.

8. Output Data Format:

   • The output data can be formatted in YUV or RGB.
   • Choose the appropriate format based on the application requirements.

9. Image Resolution and Frame Rate:

   • The IC supports 1080p resolution at a frame rate of up to 60 fps.
   • Adjust the resolution and frame rate settings according to the specific application needs.

10. Noise Reduction and Image Enhancements:

    • The CXD9936TN includes 3D noise reduction (3DNR) techniques to improve image quality.
    • Lens shading correction, auto white balance, and auto exposure control are also available to enhance image performance.

11. Initialization and Configuration:

    • Refer to the datasheet for detailed initialization sequences and configuration registers.
    • Use the provided software development kit (SDK) or reference design to simplify the setup process.

12. Handling and Storage:

    • Handle the IC with care to avoid static discharge and physical damage.
    • Store the IC in a dry and cool environment to prevent moisture-related issues.

By following these instructions, you can ensure optimal performance and reliability of the CXD9936TN in your application.