Below is the parameter table and instructions for the MR2535L, a 3.3V to 5V Logic Level Converter.

Parameter Table

Instructions

1. Power Supply Connection:

   • Connect the 3.3V or 5V power supply to the Vcc pin.
   • Ground (GND) must be connected to the common ground of both the low-voltage and high-voltage systems.

2. Signal Connections:

   • Connect the low-voltage side signals (e.g., from a 3.3V microcontroller) to the LVx pins.
   • Connect the high-voltage side signals (e.g., to a 5V device) to the HVx pins.
   • The MR2535L will automatically convert the logic levels between the two sides.

3. Bi-Directional Operation:

   • The converter supports bi-directional signal conversion, meaning it can handle signals going from low to high voltage and vice versa without additional configuration.

4. Current Limitations:

   • Ensure that the current through each channel does not exceed 100mA to avoid damage to the device.

5. Temperature Considerations:

   • Operate the device within the specified temperature range (-40°C to 85°C) to ensure reliable performance.
   • Store the device in a temperature range of -65°C to 150°C.

6. Layout Recommendations:

   • Place the MR2535L close to the devices it is interfacing with to minimize signal degradation.
   • Use short and direct traces for signal lines to reduce noise and interference.

7. Testing:

   • After assembly, test the device by applying known input signals and verifying the correct output levels on the other side.

By following these instructions, you can effectively use the MR2535L for logic level conversion in your projects.