Instructions for Use:

1. Power Supply:

   • Ensure the supply voltage (VDD) is within the range of 2.4V to 3.6V.
   • Connect the power supply to the VDD pin and ground to the GND pin.

2. Current Consumption:

   • The standby current (ISB) is typically 0.1 mA when the device is in standby mode.
   • The active current (IOP) is typically 150 mA when operating at full resolution and 30 fps.

3. Pixel Configuration:

   • The sensor has a pixel size of 5.6 μm x 5.6 μm and an active area of 1280 x 960 pixels.
   • The image sensor size is 1/3 inch.

4. Frame Rate and Sensitivity:

   • The typical frame rate (fR) is 30 fps at full resolution.
   • The sensitivity (S) is 1.2 V/lux-sec at 50 IRE and 50% contrast.

5. Signal Quality:

   • The signal-to-noise ratio (SNR) is typically 40 dB.
   • The dynamic range (DR) is 60 dB.

6. Shutter Mode:

   • The ICX285AL uses a global shutter mode.

7. Output Interface:

   • The output interface is MIPI CSI-2. Ensure the host system supports this interface for data transmission.

8. Temperature Considerations:

   • The operating temperature (Toper) range is from -20°C to 70°C.
   • The storage temperature (Tstg) range is from -40°C to 85°C.

9. Handling and Storage:

   • Handle the IC with care to avoid static damage.
   • Store the IC in a dry, cool place within the specified storage temperature range.

10. Initialization and Configuration:

    • Refer to the datasheet for detailed initialization sequences and configuration registers.
    • Use the appropriate software or firmware to configure the sensor settings according to your application requirements.