Instructions:

1. Handling:

   • Handle with care to avoid damage.
   • Use appropriate ESD protection to prevent static damage.

2. Mounting:

   • Place the component on the PCB according to the footprint provided in the datasheet.
   • Ensure that the orientation is correct to match the circuit design.

3. Soldering:

   • Preheat the PCB to reduce thermal shock.
   • Use a soldering iron with a temperature setting between 300°C and 350°C.
   • Apply a small amount of flux to the pads.
   • Solder each pad for 2 to 3 seconds, ensuring good wetting and a smooth fillet.
   • Allow the component to cool naturally after soldering.

4. Inspection:

   • Visually inspect the solder joints for any defects such as cold solder joints, bridges, or insufficient solder.
   • Use a multimeter to verify the resistance values and ensure they are within the specified tolerance.

5. Testing:

   • Perform functional testing of the circuit to ensure the resistor network is operating correctly.
   • Check for any short circuits or open circuits.

6. Storage:

   • Store in a dry, cool place away from direct sunlight.
   • Keep in original packaging until ready for use to protect against moisture and static damage.