Share:
Specifications
SKU: 4109097
| Parameter | Description | Value |
|---|---|---|
| Device Type | Gigabit Ethernet Physical Layer Transceiver (PHY) | 88E6161-LG02 |
| Package | 48-pin QFN (Quad Flat No-lead) | 7x7 mm |
| Operating Voltage | Supply Voltage (VCC) | 3.3V ± 5% |
| Operating Temperature | Industrial Temperature Range | -40°C to +85°C |
| Data Rate | Ethernet Data Rate | 10/100/1000 Mbps |
| Interface | Media Independent Interface (MII) | RGMII, RMII |
| Power Consumption | Typical Power Consumption (Active Mode) | 350 mW |
| Standby Power | Typical Power Consumption (Standby Mode) | 100 mW |
| EMI Performance | Electromagnetic Interference (EMI) | Low EMI Design |
| ESD Protection | Electrostatic Discharge (ESD) Protection | ±4 kV HBM |
| Wake-on-LAN | Wake-on-LAN Support | Yes |
| Auto-Negotiation | Auto-Negotiation for Speed and Duplex | Yes |
| Cable Diagnostics | Cable Diagnostics Support | Yes |
| Jumbo Frame Support | Jumbo Frame Support (up to 9 KB) | Yes |
| LED Control | LED Control for Link Status, Activity, and Speed | Yes |
| Package Marking | Package Marking | 88E6161-LG02 |
Instructions for Use
Power Supply:
- Ensure that the supply voltage (VCC) is within the specified range of 3.3V ± 5%.
- Use a stable power supply with appropriate decoupling capacitors to minimize noise.
Temperature Range:
- Operate the device within the industrial temperature range of -40°C to +85°C to ensure reliable performance.
Interface Configuration:
- Connect the device to the host controller using the RGMII or RMII interface as required.
- Ensure proper signal integrity and termination for reliable data transmission.
Auto-Negotiation:
- Enable auto-negotiation to automatically configure the speed and duplex settings between the PHY and the link partner.
Cable Diagnostics:
- Utilize the cable diagnostics feature to detect and report issues with the Ethernet cable, such as open pairs or short circuits.
Wake-on-LAN:
- Configure the wake-on-LAN feature to allow the device to wake up from a low-power state when a specific network packet is received.
LED Control:
- Program the LED control registers to indicate link status, activity, and speed using the on-board LEDs.
Jumbo Frames:
- Enable jumbo frame support if your application requires the transmission of large packets (up to 9 KB).
EMI Considerations:
- Follow recommended PCB layout guidelines to minimize electromagnetic interference (EMI) and ensure compliance with regulatory standards.
ESD Protection:
- Handle the device with care to avoid electrostatic discharge (ESD) damage. Use appropriate ESD protection measures during handling and installation.
For detailed register maps and configuration settings, refer to the datasheet provided by the manufacturer.
(For reference only)Inquiry - 88E6161-LG02
