Share:
Specifications
SKU: 4143098
High Performance E2 PLD
| Parameter | Description | Value | Unit |
|---|---|---|---|
| Device Type | Complex Programmable Logic Device | ATF22V10C-10JC | |
| Package Type | Ceramic Dual In-Line (DIL) | 24-Pin | |
| Operating Voltage | Supply Voltage | 5.0 | V |
| Operating Temperature | Junction Temperature Range | -40 to +85 | °C |
| Storage Temperature | Storage Temperature Range | -65 to +150 | °C |
| Maximum Power Dissipation | Total Power Dissipation | 500 | mW |
| Input Low Voltage | Maximum Input Low Voltage | 0.8 | V |
| Input High Voltage | Minimum Input High Voltage | 2.0 | V |
| Output Low Voltage | Maximum Output Low Voltage | 0.5 | V |
| Output High Voltage | Minimum Output High Voltage | 2.4 | V |
| Propagation Delay Time | Typical Propagation Delay Time | 10 | ns |
| Power-up Time | Maximum Power-up Time | 100 | μs |
| Configuration Mode | Configuration Modes | In-System, Parallel, Serial | |
| Configuration Memory | Configuration Memory Size | 256 x 9 bits | |
| Macrocells | Number of Macrocells | 20 | |
| I/O Pins | Number of I/O Pins | 20 | |
| Internal Oscillator | Internal Oscillator Frequency Range | 0 to 50 | MHz |
| ESD Protection | Human Body Model (HBM) | 2000 | V |
Instructions for Use:
Power Supply:
- Ensure the supply voltage is within the specified range (5.0V).
- Use appropriate decoupling capacitors (0.1μF and 10μF) close to the power pins to minimize noise.
Configuration:
- The ATF22V10C-10JC can be configured using In-System Programming (ISP), Parallel, or Serial methods.
- Refer to the device datasheet for specific configuration protocols and pin assignments.
Input/Output Handling:
- Ensure input voltages are within the valid range (0.8V to 2.0V for low and high states).
- Outputs should not be left floating; use pull-up or pull-down resistors as needed.
Temperature Management:
- Operate the device within the specified temperature range (-40°C to +85°C).
- Ensure adequate cooling if operating near the maximum power dissipation limit.
ESD Protection:
- Handle the device with ESD precautions to avoid damage.
- Use grounded wrist straps and anti-static mats when handling the device.
Programming:
- Use compatible programming software and hardware to configure the device.
- Verify the configuration data before programming to avoid errors.
Storage:
- Store the device in a dry, temperature-controlled environment to prevent damage.
- Follow the storage temperature guidelines (-65°C to +150°C).
Handling:
- Avoid applying excessive force to the pins.
- Handle the device by the edges to minimize the risk of damage.
Inquiry - ATF22V10C-10JC
