Instructions for Using AD648JRZ

1. Power Supply:

   • Ensure the supply voltage (V_CC) is within the range of 5V to 30V.
   • The quiescent current per channel should not exceed 3.5mA.

2. Input Signals:

   • The common mode input voltage range is from -0.3V to V_CC + 0.3V.
   • Avoid exceeding these limits to prevent damage to the device.

3. Output Signals:

   • The output voltage swing is from 0.1V to V_CC - 0.1V with no load.
   • Ensure that the load does not pull the output beyond these limits.

4. Bandwidth and Slew Rate:

   • The -3 dB bandwidth for a gain of 1 is 64 MHz.
   • The slew rate is 1500 V/μs, which is important for handling large signal changes quickly.

5. Gain and Linearity:

   • The large signal voltage gain at a gain of 1 is 100 dB.
   • Ensure the gain settings are appropriate for your application to maintain linearity.

6. Offset and Bias:

   • The input bias current is typically 2 nA, and the input offset current is 0.5 nA.
   • The input offset voltage is 1 mV.
   • These parameters can affect the accuracy of your measurements, so they should be considered in your design.

7. Power Supply Rejection Ratio (PSRR):

   • The PSRR at 10 kHz is 90 dB, indicating good rejection of power supply noise.

8. Common Mode Rejection Ratio (CMRR):

   • The CMRR at 10 kHz is 80 dB, indicating good rejection of common mode signals.

9. Handling and Storage:

   • Handle the device with care to avoid static discharge.
   • Store in a dry environment to prevent moisture damage.

10. Application Notes:

    • Refer to the datasheet for detailed application notes and circuit diagrams.
    • Consider using bypass capacitors to stabilize the power supply and reduce noise.