Share:
Specifications
SKU: 4176587
MULTIPLEXER 8X1 16SOIC
| Parameter | Symbol | Min | Typ | Max | Unit | Description |
|---|---|---|---|---|---|---|
| Supply Voltage | VDD | 2.7 | - | 5.5 | V | Operating supply voltage range |
| Quiescent Current | IQ | - | 1.0 | - | μA | Supply current with no signal applied (per channel) |
| ON Resistance | RON | - | 0.9 | - | Ω | Typical resistance when switch is on |
| OFF Leakage Current | IOFF | - | 1.0 | - | nA | Maximum leakage current when switch is off |
| Input Signal Range | VIN | -0.3 | - | VDD+0.3 | V | Input voltage range relative to supply voltage |
| Switching Time | tSW | - | 1.0 | - | μs | Time required for the switch to turn on or off |
| Storage Temperature Range | TSTG | -65 | - | 150 | °C | Temperature range for storage |
| Operating Temperature Range | TA | -40 | - | 85 | °C | Operating temperature range |
| ESD Rating | HBM | - | - | 2000 | V | Human Body Model Electrostatic Discharge rating |
| Package Type | - | - | - | - | - | 16-lead SOIC (Small Outline Integrated Circuit) package |
Instructions for Using ADG438FBRZ
Power Supply:
- Ensure the supply voltage (VDD) is within the specified range of 2.7V to 5.5V.
- Connect the power supply to the VDD and GND pins.
Signal Connections:
- Connect the input signals to the appropriate input pins (IN1, IN2, etc.).
- Ensure the input signals do not exceed the input signal range of -0.3V to VDD + 0.3V.
Control Signals:
- Apply control signals to the control pins (S0, S1, EN) to select the desired channel and enable/disable the switch.
- The enable pin (EN) should be set to high to activate the switch and low to disable it.
Output Connections:
- Connect the output pins (OUT1, OUT2, etc.) to the load or next stage of the circuit.
Handling and Storage:
- Handle the device with care to avoid ESD damage. Use proper ESD protection measures.
- Store the device in a dry, temperature-controlled environment within the specified storage temperature range (-65°C to 150°C).
Thermal Management:
- Ensure adequate heat dissipation if operating at higher temperatures or under high current conditions.
Testing:
- Verify the operation of the switch by measuring the ON resistance (RON) and OFF leakage current (IOFF).
- Test the switching time (tSW) to ensure it meets the specified performance.
Layout Considerations:
- Place decoupling capacitors close to the power supply pins to minimize noise and improve stability.
- Use short, wide traces for signal paths to reduce parasitic inductance and capacitance.
By following these instructions, you can ensure optimal performance and reliability of the ADG438FBRZ in your application.
(For reference only)Inquiry - ADG438FBRZ
