Specifications
SKU: 4448210
Parameter | Symbol | Min | Typ | Max | Unit | Conditions |
---|---|---|---|---|---|---|
Drain-Source Voltage | VDS | - | 600 | - | V | |
Gate-Source Voltage | VGS | -15 | - | 20 | V | |
Continuous Drain Current | ID | - | 12 | - | A | TC = 25°C |
Continuous Drain Current | ID | - | 8.4 | - | A | TC = 100°C |
Pulse Drain Current | IDpeak | - | 36 | - | A | tp = 10 μs, IG = 1 A |
Power Dissipation | PTOT | - | - | 190 | W | TC = 25°C |
Junction Temperature | TJ | - | - | 175 | °C | |
Storage Temperature | TSTG | -55 | - | 150 | °C |
Instructions for Using F12NM60N
Handling Precautions:
- The F12NM60N is sensitive to electrostatic discharge (ESD). Use proper ESD protection equipment and follow ESD handling procedures.
- Avoid exposing the device to high temperatures or humidity.
Mounting:
- Ensure that the mounting surface is clean and free from contaminants.
- Apply thermal paste or a thermal pad between the device and the heatsink to improve heat dissipation.
- Tighten the mounting screws to the recommended torque to ensure good thermal contact without damaging the device.
Biasing:
- The gate-source voltage (VGS) should be kept within the specified limits (-15V to +20V) to avoid damaging the device.
- For optimal performance, use a gate resistor to limit the gate current and reduce switching losses.
Operation:
- The drain-source voltage (VDS) should not exceed 600V to prevent breakdown.
- The continuous drain current (ID) should be limited to 12A at 25°C and 8.4A at 100°C to avoid overheating.
- For pulse operation, the peak drain current (IDpeak) can reach up to 36A for short durations (10 μs).
Thermal Management:
- Monitor the junction temperature (TJ) to ensure it does not exceed 175°C.
- Use a heatsink with adequate thermal resistance to keep the device within safe operating temperatures.
Storage:
- Store the device in a dry, cool place away from direct sunlight.
- Keep the device in its original packaging until ready for use to protect against moisture and static damage.
Testing:
- Before installing the device in a circuit, perform a visual inspection to ensure there are no physical damages.
- Use a multimeter to check the continuity and resistance values to verify the device is functioning correctly.
Inquiry - F12NM60N