Instructions for Use:

1. Power Supply:

   • Connect the positive terminal of the power supply to the VCC pin.
   • Connect the negative terminal of the power supply to the GND pin.
   • Ensure the operating voltage is within the range of 2.7V to 5.5V.

2. Output Connection:

   • Connect the output signal to the OUT pin.
   • The output frequency is typically 1 kHz with a duty cycle of 50% (±5%).

3. Standby Mode:

   • To put the device into standby mode, set the EN (enable) pin to low (GND).
   • The standby current is approximately 0.1 μA.

4. Operating Mode:

   • To activate the device, set the EN pin to high (VCC).
   • The operating current is typically 20 mA.

5. Temperature Considerations:

   • Ensure the operating temperature is between -40°C and 85°C.
   • Store the device in an environment where the temperature ranges from -65°C to 150°C.

6. Output Characteristics:

   • The output voltage at 5V supply is typically 0.9V to 1.1V.
   • The rise and fall times of the output signal are both approximately 1 μs.

7. Handling and Storage:

   • Handle the device with care to avoid damage.
   • Store in a dry, cool place to prevent moisture and temperature-related issues.

8. Testing:

   • Before integrating the device into your circuit, test it with a simple setup to ensure proper functionality.
   • Use a multimeter to verify the output voltage and frequency.

9. Troubleshooting:

   • If the device does not function as expected, check the power supply connections and ensure the enable pin is correctly set.
   • Verify that the operating conditions (voltage, temperature) are within the specified limits.