Instructions for Use

1. Power Supply:

   • Connect the VCC pin to a 5V DC power supply.
   • Connect the GND pin to the ground of the power supply.

2. Trigger Pulse:

   • Send a 10μs TTL pulse to the TRIG pin to start the ranging.
   • The sensor will automatically send out an ultrasonic burst and wait for the echo.

3. Echo Signal:

   • The ECHO pin will output a high-level pulse whose duration is proportional to the distance to the object.
   • Measure the duration of the high-level pulse using a microcontroller or timer.
   • Distance (in cm) can be calculated using the formula: [ text = frac{text{Pulse Duration (in μs)}} ]

4. Maximum Ranging Interval:

   • To ensure accurate readings, the maximum ranging interval should be at least 60ms between two trigger pulses.

5. Mounting:

   • Mount the sensor in a stable position with the ultrasonic transducer facing the area to be measured.
   • Avoid placing the sensor near reflective surfaces that could cause false readings.

6. Interference:

   • Ensure that multiple sensors are not placed too close to each other to avoid interference.
   • If using multiple sensors, stagger the trigger pulses to prevent overlapping signals.