Instructions for Use

1. Power Supply:

   • Connect VCC to the supply voltage (2.5V to 5.5V).
   • Connect GND to ground.

2. Clock Input (CLK):

   • Apply a clock signal to the CLK pin to synchronize data transfer.
   • The maximum clock frequency is 10MHz.

3. Data Input/Output (DQ):

   • DQ is used for both data input and output.
   • During read operations, data is output on the rising edge of the clock.
   • During write operations, data is input on the falling edge of the clock.

4. Chip Select (CS):

   • CS must be low to enable the device.
   • When CS is high, the device is in standby mode.

5. Write Protect (WP):

   • WP can be used to prevent accidental writes.
   • Set WP high to enable write protection.
   • Set WP low to allow writing.

6. Serial Data Protocol:

   • The 93C06.6 uses a simple serial protocol for communication.
   • The protocol involves sending commands and addresses followed by data.
   • Common commands include:
     • Read Command (10R): Read data from a specified address.
     • Write Command (01W): Write data to a specified address.
     • Write Enable (0111): Enable writing to the device.
     • Write Disable (0101): Disable writing to the device.

7. Timing Diagrams:

   • Refer to the datasheet for detailed timing diagrams to ensure proper synchronization of signals.

8. Handling Precautions:

   • Handle the device with care to avoid static damage.
   • Ensure proper grounding and power sequencing when integrating the device into a circuit.

9. Storage:

   • Store the device in a dry, cool place to maintain its performance and longevity.

10. End-of-Life Considerations:

    • Follow environmental regulations for disposal and recycling of the device.