Specifications
SKU: 6488343
IC OPAMP GP 1.9MHZ RRO 14SOIC
Parameter | Symbol | Conditions | Min | Typ | Max | Unit |
---|---|---|---|---|---|---|
Supply Voltage | VCC | Operating Range | 2.7 | - | 6.0 | V |
Input Offset Voltage | VIO | VCC = 5V, TA = 25°C | -0.5 | 0.1 | 0.5 | mV |
Input Bias Current | IB | VCC = 5V, TA = 25°C | - | 25 | - | nA |
Input Offset Current | IOS | VCC = 5V, TA = 25°C | - | 3 | - | nA |
Common-Mode Rejection Ratio | CMRR | VCC = 5V, TA = 25°C, f = 0.1 Hz | 80 | - | 100 | dB |
Power Supply Rejection Ratio | PSRR | VCC = 5V, TA = 25°C, f = 10 Hz | 80 | - | 100 | dB |
Slew Rate | SR | VCC = 5V, TA = 25°C | 0.4 | - | 0.6 | V/μs |
Bandwidth (Unity Gain) | BWUG | VCC = 5V, TA = 25°C | - | 1.0 | - | MHz |
Output Voltage Swing | VOUT | VCC = 5V, TA = 25°C, RL = 10kΩ | 0.2 | - | 4.8 | V |
Quiescent Current per Amplifier | IQ | VCC = 5V, TA = 25°C | - | 350 | - | μA |
Instructions for Use:
- Power Supply: The TLC2202AID operates over a supply voltage range of 2.7V to 6.0V. Ensure that the power supply is stable and within this range to avoid damage or erratic behavior.
- Input Signals: The input signals should be within the common-mode input voltage range, which is typically from 0V to VCC - 1.5V. Exceeding these limits can cause distortion or damage.
- Output Load: The output can swing from approximately 0.2V to VCC - 0.2V when driving a 10kΩ load. For different loads, ensure the output remains within safe operating limits.
- Temperature Considerations: The device is rated for operation from -40°C to 125°C. However, performance parameters may vary with temperature, so it is advisable to consult the datasheet for temperature-dependent specifications.
- Slew Rate and Bandwidth: The slew rate of 0.4 to 0.6 V/μs and unity gain bandwidth of 1.0 MHz make the TLC2202AID suitable for general-purpose applications but not high-speed signal processing.
- Quiescent Current: Each amplifier consumes about 350 μA at 25°C. This value increases with temperature, so consider this in power budget calculations.
- Stability and Compensation: The TLC2202AID is internally compensated for unity gain stability. No external compensation is required for most applications.
- Handling Precautions: The device is sensitive to electrostatic discharge (ESD). Use proper ESD protection measures during handling and installation.
For detailed application circuits and further information, refer to the full datasheet provided by Texas Instruments.
(For reference only)Inquiry - TLC2202AID