Share:
Specifications
SKU: 7545772
IC FF D-TYPE SNGL 8BIT 20SOIC
| Parameter | Symbol | Conditions | Min | Typ | Max | Unit |
|---|---|---|---|---|---|---|
| Supply Voltage | VCC | 2.0 | 5.5 | V | ||
| Input Low Voltage | VIL | VCC = 5.0V | 0.8 | V | ||
| Input High Voltage | VIH | VCC = 5.0V | 2.0 | V | ||
| Output Low Voltage | VOL | IOL = 16mA | 0.3 | V | ||
| Output High Voltage | VOH | IOH = -4mA | 4.5 | V | ||
| Propagation Delay Time | tpd | VCC = 5.0V, TA = 25°C | 6 | 10 | ns | |
| Power Dissipation | PD | Continuous | 360 | mW | ||
| Operating Temperature | TOP | Storage | -40 | 85 | °C | |
| Storage Temperature | TSTG | -65 | 150 | °C |
Instructions for Use:
Power Supply:
- Ensure the supply voltage (VCC) is within the range of 2.0V to 5.5V.
- Connect VCC to the power supply and GND to ground.
Input Levels:
- For logic low, input voltages should be below 0.8V when VCC is 5.0V.
- For logic high, input voltages should be above 2.0V when VCC is 5.0V.
Output Levels:
- When the output is low, the voltage will be less than 0.3V with a load current of 16mA.
- When the output is high, the voltage will be greater than 4.5V with a load current of -4mA.
Propagation Delay:
- The propagation delay time (tpd) is typically between 6ns and 10ns at 25°C and VCC = 5.0V.
Power Dissipation:
- The maximum power dissipation (PD) is 360mW. Ensure adequate heat dissipation if operating near this limit.
Temperature Range:
- The device can operate within a temperature range of -40°C to 85°C.
- Store the device between -65°C and 150°C.
Handling:
- Handle the device with care to avoid static damage. Use proper ESD protection measures.
- Avoid exposing the device to excessive humidity or mechanical stress.
Pin Configuration:
- Refer to the datasheet for the specific pin configuration and ensure correct connections to avoid damage.
Testing:
- Perform initial testing under controlled conditions to verify correct operation before integrating into a larger system.
Inquiry - SN74BCT574DWR
