Share:
Specifications
SKU: 7627559
- Converter, Analog and Digital Satellite STB Receivers/SatTV Voltage Regulator IC 1 Output IPPAK
| Parameter | Description | Value |
|---|---|---|
| Part Number | Part number of the device | LNBP8LIT |
| Type | Type of component | Low Noise Block |
| Frequency Range | Operating frequency range | 950 MHz to 2150 MHz |
| Noise Figure | Measure of degradation of the signal-to-noise ratio | 0.8 dB |
| Gain | Amplification factor | 60 dB |
| Power Supply | Voltage required for operation | 13 V to 24 V DC |
| Current Consumption | Typical current consumption during operation | 150 mA |
| Output Impedance | Output impedance of the device | 75 Ω |
| Input Impedance | Input impedance of the device | 75 Ω |
| Connector Type | Type of connectors used | F-type |
| Operating Temperature | Temperature range for reliable operation | -40°C to +60°C |
| Storage Temperature | Temperature range for storage | -55°C to +85°C |
| Dimensions | Physical dimensions (W x H x D) | 120 mm x 80 mm x 50 mm |
| Weight | Weight of the device | 300 g |
Instructions for Use
Installation:
- Ensure that the LNBP8LIT is installed in a location with proper ventilation to avoid overheating.
- Connect the input and output cables using F-type connectors. The input should be connected to the satellite dish, and the output should be connected to the receiver.
Power Supply:
- The LNBP8LIT requires a DC power supply between 13 V and 24 V. Ensure that the polarity is correct to avoid damage to the device.
- The power supply can be provided by the satellite receiver or an external power supply.
Operation:
- Once the LNBP8LIT is powered and connected, it will amplify the received satellite signals and convert them to a lower frequency range suitable for transmission to the receiver.
- Monitor the signal strength on your satellite receiver to ensure optimal performance.
Maintenance:
- Regularly check the connections and ensure they are tight and free from corrosion.
- If the device is exposed to harsh environmental conditions, inspect it periodically for signs of damage or wear.
Troubleshooting:
- No Signal: Check all connections and ensure the power supply is within the specified range.
- Weak Signal: Adjust the position of the satellite dish or check for any obstructions.
- Interference: Ensure that the LNBP8LIT is not placed near sources of electromagnetic interference.
Safety Precautions:
- Do not operate the LNBP8LIT in environments where the temperature exceeds the specified operating range.
- Avoid exposing the device to excessive moisture or humidity.
- Always disconnect the power supply before performing any maintenance or installation tasks.
Inquiry - LNBP8LIT
