Share:
Specifications
SKU: 8918592
| Parameter | Symbol | Conditions | Min | Typ | Max | Unit |
|---|---|---|---|---|---|---|
| Supply Voltage | VCC | Operating | 2.0 | - | 5.5 | V |
| Input Voltage (High Level) | VIH | - | 2.0 | - | VCC | V |
| Input Voltage (Low Level) | VIL | - | 0 | - | 0.8 | V |
| Output Voltage (High Level) | VOH | IOL = -100 μA | - | - | VCC - 0.1 | V |
| Output Voltage (Low Level) | VOL | IOL = 100 μA | 0 | - | 0.1 | V |
| Propagation Delay Time (High to Low) | tPLH | VCC = 5.0V, TA = 25°C | - | 15 | - | ns |
| Propagation Delay Time (Low to High) | tPHL | VCC = 5.0V, TA = 25°C | - | 15 | - | ns |
| Power Dissipation | PD | Maximum | - | - | 100 | mW |
| Operating Temperature Range | TA | - | -40 | - | 85 | °C |
| Storage Temperature Range | TSTG | - | -65 | - | 150 | °C |
Instructions for Use:
Power Supply:
- Ensure the supply voltage (VCC) is within the range of 2.0V to 5.5V.
- Connect the ground (GND) pin to a stable reference ground.
Input Signals:
- Input voltages should be within the specified ranges for high (VIH) and low (VIL) levels.
- Avoid exceeding the maximum input voltage (VCC).
Output Signals:
- The output voltages (VOH and VOL) will be close to the supply voltage or ground, depending on the state of the input.
- Ensure that the load connected to the output does not exceed the maximum current ratings.
Propagation Delay:
- The propagation delay times (tPLH and tPHL) are critical for timing considerations in your circuit design.
- These values are typical at 5.0V and 25°C; they may vary with different supply voltages and temperatures.
Temperature Considerations:
- The device is designed to operate within the temperature range of -40°C to 85°C.
- Store the device in a temperature range of -65°C to 150°C.
Power Dissipation:
- The maximum power dissipation is 100mW. Ensure adequate heat dissipation if operating near this limit.
Handling:
- Handle the device with care to avoid static damage.
- Follow standard ESD (Electrostatic Discharge) precautions during handling and assembly.
Mounting:
- Ensure proper soldering techniques to avoid thermal stress on the device.
- Use appropriate mounting techniques to ensure reliable connections and mechanical stability.
By following these parameters and instructions, you can ensure optimal performance and reliability of the TC74VHC273FT(EL) in your application.
(For reference only)Inquiry - TC74VHC273FT(EL)
