Instructions for Use:

1. Handling:

   • Handle with care to avoid damage.
   • Use appropriate ESD (Electrostatic Discharge) protection when handling.

2. Soldering:

   • Preheat the board to 100-120°C.
   • Apply solder paste to the pads.
   • Place the resistor on the pads.
   • Solder at a temperature of 230-250°C for 3-4 seconds.
   • Allow the board to cool naturally.

3. Mounting:

   • Ensure the resistor is aligned correctly on the PCB.
   • Avoid excessive mechanical stress on the component.

4. Storage:

   • Store in a dry, cool place.
   • Keep away from direct sunlight and sources of heat.

5. Inspection:

   • Visually inspect the solder joints for quality.
   • Ensure there are no shorts or open circuits.

6. Testing:

   • Measure the resistance using a multimeter to confirm it meets the specified value.
   • Test the power rating by applying the rated voltage and measuring the current.