Instructions for Use:

1. Input Voltage (VIN):

   • Ensure the input voltage is within the range of 2.7V to 5.5V.
   • Avoid applying voltages outside this range to prevent damage to the device.

2. Output Voltage (VOUT):

   • The BP2867G provides a fixed output voltage of 3.3V.
   • No external components are required for setting the output voltage.

3. Output Current (IOUT):

   • The device can supply up to 600mA continuously.
   • For higher current requirements, consider using a more powerful regulator or parallel operation.

4. Quiescent Current (IQ):

   • The quiescent current is typically 2.5μA when the input voltage is 3.3V and there is no load.
   • This low quiescent current makes the device suitable for battery-powered applications.

5. Dropout Voltage (VDROPOUT):

   • The dropout voltage is typically 200mV at an output current of 300mA with an input voltage of 3.3V.
   • Ensure that the input voltage is at least 200mV higher than the output voltage to maintain regulation.

6. Load Regulation:

   • The load regulation is typically 1% over the output current range from 0mA to 600mA.
   • This indicates the stability of the output voltage under varying load conditions.

7. Line Regulation:

   • The line regulation is typically 0.1%/V over the input voltage range from 2.7V to 5.5V.
   • This indicates the stability of the output voltage under varying input conditions.

8. Ripple Rejection:

   • The ripple rejection is typically 60dB at a frequency of 100Hz.
   • This helps in filtering out noise from the input power supply.

9. Operating Temperature (TOPR):

   • The device can operate within the temperature range of -40°C to 125°C.
   • Ensure adequate heat dissipation if operating at high temperatures or high currents.

10. Storage Temperature (TSTG):

    • The device can be stored within the temperature range of -65°C to 150°C.
    • Avoid exposing the device to extreme temperatures for extended periods.

Additional Notes:

• Capacitors:

  • Use a 1μF ceramic capacitor on the input side and a 1μF ceramic capacitor on the output side for stability and noise reduction.
  • Place these capacitors as close as possible to the regulator to minimize parasitic inductance.

• PCB Layout:

  • Ensure proper PCB layout to minimize noise and improve thermal performance.
  • Use wide traces for power lines and ground to reduce resistance and inductance.

• Thermal Management:

  • If the device is expected to operate at high currents or in high ambient temperatures, consider adding a heatsink or using a larger PCB area for heat dissipation.