Instructions for Use

1. Installation:

   • Ensure the installation location is well-ventilated and free from dust and moisture.
   • Mount the MDS100-14 on a stable surface using the provided mounting brackets.
   • Connect the three-phase input power lines (L1, L2, L3) and the ground wire (PE) to the corresponding terminals.

2. Initial Setup:

   • Turn off the main power supply before making any connections.
   • Set the output voltage and current using the potentiometers or control panel as per your application requirements.
   • Verify all connections are secure and correct.

3. Operation:

   • Turn on the main power supply.
   • Observe the display to ensure the output voltage and current are within the desired range.
   • If the device detects any faults, it will automatically shut down. Check the fault codes and take appropriate action.

4. Maintenance:

   • Regularly inspect the cooling fan and clean any dust accumulation to ensure proper air flow.
   • Check all electrical connections periodically to ensure they remain tight and secure.
   • Refer to the user manual for detailed maintenance procedures and troubleshooting tips.

5. Safety Precautions:

   • Always disconnect the power before performing any maintenance or adjustments.
   • Do not operate the device in environments with explosive gases or flammable materials.
   • Use only the specified input voltage and do not exceed the rated output current to avoid damage to the device.

For more detailed information, refer to the user manual provided with the MDS100-14.