Instructions:

1. Handling:

   • Handle with care to avoid damaging the leads or body.
   • Do not apply excessive force when inserting into a circuit board.

2. Mounting:

   • Ensure the leads are properly aligned with the holes on the circuit board.
   • Solder the leads quickly to avoid overheating the resistor.
   • Trim the leads to a length of approximately 1mm after soldering.

3. Storage:

   • Store in a dry, cool place away from direct sunlight.
   • Keep in original packaging until ready for use to prevent damage.

4. Usage:

   • Verify the resistance value using a multimeter before installation.
   • Ensure the operating temperature range is suitable for the application.

5. Disposal:

   • Dispose of the resistor according to local regulations for electronic waste.