Instructions for Use:

1. Connect Input Power:

   • Connect the positive terminal of your power source to the VIN pin.
   • Connect the negative terminal of your power source to the GND pin.

2. Set Output Voltage:

   • Adjust the output voltage using the potentiometer (trimmer) on the module.
   • Use a multimeter to measure the output voltage at VOUT and GND while adjusting the potentiometer until the desired voltage is achieved.

3. Connect Load:

   • Connect the load to the VOUT and GND pins.
   • Ensure the load does not exceed the maximum output current to avoid damage.

4. Monitor Operation:

   • Check the temperature of the module during operation to ensure it does not overheat.
   • If the module gets too hot, reduce the load or improve cooling.

5. Storage:

   • Store the module in a dry, cool place away from direct sunlight and corrosive materials.

6. Safety Precautions:

   • Do not short-circuit the output.
   • Avoid operating the module outside its specified voltage and current ranges.
   • Use appropriate fuses or circuit breakers to protect against overcurrent conditions.