Share:
Specifications
SKU: 11194583
You deserve it
| Parameter | Description | Value | Unit |
|---|---|---|---|
| Device | Microcontroller | MC9RS08KA1CSC | - |
| Family | RS08 | - | - |
| Package | SOIC-20 | - | - |
| Operating Voltage (VDD) | Supply voltage range | 2.0 to 5.5 | V |
| Clock Frequency | Maximum clock frequency | 24 | MHz |
| Flash Memory | Program memory size | 2 | KB |
| RAM | Data memory size | 128 | B |
| EEPROM | Non-volatile data memory | No | - |
| I/O Ports | Number of I/O pins | 16 | - |
| Timers | Number of timers | 1 | - |
| ADC | Analog-to-Digital Converter channels | 7 | - |
| DAC | Digital-to-Analog Converter channels | No | - |
| Communication Interfaces | Available communication interfaces | SPI, I2C, UART | - |
| Operating Temperature | Operating temperature range | -40 to 85 | °C |
| Storage Temperature | Storage temperature range | -65 to 150 | °C |
| Power Consumption | Active mode power consumption at 3.3V, 24MHz | 5.5 | mA |
| Low Power Modes | Available low power modes | Stop, Wait, VLPS | - |
| Wake-up Sources | Wake-up sources from low power modes | Pin, RTC, LVD | - |
Instructions for Use
Power Supply:
- Ensure the supply voltage (VDD) is within the specified range of 2.0 to 5.5V.
- Connect the VSS pin to ground.
Clock Configuration:
- The device supports an internal oscillator and external crystal/clock input.
- For external clock, connect the clock signal to the XTAL1 pin.
- For external crystal, connect the crystal between XTAL1 and XTAL2 pins.
Program Memory:
- The 2KB flash memory can be programmed using the Serial Wire Debug (SWD) interface or other supported programming methods.
- Use a compatible programmer and software to write your code to the flash memory.
Data Memory:
- The 128B RAM is used for storing variables and temporary data during program execution.
I/O Pins:
- Configure the I/O pins as inputs or outputs using the appropriate register settings.
- Use pull-up or pull-down resistors as needed for stable operation.
Timers:
- The single timer can be configured for various timing and counting functions.
- Refer to the datasheet for specific timer configuration registers.
ADC:
- The 7-channel ADC can be used to measure analog signals.
- Configure the ADC channels and start conversions using the ADC control registers.
Communication Interfaces:
- SPI, I2C, and UART interfaces are available for communication with other devices.
- Configure the communication settings and enable the interfaces as required.
Low Power Modes:
- To reduce power consumption, use the Stop, Wait, or Very Low Power Stop (VLPS) modes.
- Wake up the device using pin interrupts, Real-Time Clock (RTC), or Low-Voltage Detect (LVD).
Operating Temperature:
- Ensure the operating temperature is within the specified range of -40°C to 85°C.
- Store the device within the storage temperature range of -65°C to 150°C.
Handling Precautions:
- Handle the device with care to avoid damage from electrostatic discharge (ESD).
- Follow proper soldering and handling procedures to ensure reliable operation.
Inquiry - MC9RS08KA1CSC
