Instructions for Using EPM7064STC100-10

1. Power Supply:

   • Ensure that the supply voltage (VCC) is within the range of 4.75V to 5.25V.
   • The I/O voltage (VCCIO) should also be within the same range.

2. Configuration:

   • The default configuration mode is Active Serial (AS). You can configure the device using a serial data stream.
   • Optional configuration modes include Passive Serial (PS), JTAG, and AS with Byte-wide Data Bus (ASx8).
   • Configuration time is typically 10 ms, with a maximum of 20 ms.

3. Logic Cells:

   • The device has 640 logic cells, with 320 dedicated and 320 combinational.
   • Each logic cell can perform both combinatorial and sequential functions.

4. Flip-Flops:

   • There are 640 flip-flops available for use in your design.

5. Embedded Array Blocks (EABs):

   • The device includes 8 EABs, each with 16 Kbits of RAM and ROM.
   • Each EAB also supports an 8 x 8 multiplier.

6. I/O Pins:

   • The device has 72 I/O pins, distributed across 4 banks.
   • Each bank supports VCCIO ranges of 3.3V and 5V.
   • Supported I/O standards include LVTTL, LVCMOS33, and LVCMOS50.

7. Clock Resources:

   • The device has 4 global clocks and 4 regional clocks.
   • A single Phase-Locked Loop (PLL) is available for clock management.

8. Power Consumption:

   • The static power consumption is typically 50 mW.
   • The dynamic power consumption is typically 100 mW at 100 MHz.

9. Operating Temperature:

   • Ensure that the operating temperature is within the range of -40°C to +85°C.

10. Handling:

    • Handle the device with care to avoid electrostatic discharge (ESD) damage.
    • Follow proper handling and storage guidelines as specified in the device datasheet.

For more detailed information, refer to the official datasheet and application notes provided by the manufacturer.