Share:
Specifications
SKU: 11203502
IC VREF SHUNT ADJ TO92-3
| Parameter | Symbol | Min | Typ | Max | Unit | Description |
|---|---|---|---|---|---|---|
| Operating Voltage | Vcc | 2.7 | - | 5.5 | V | Supply voltage range |
| Output Current | Iout | - | 100 | 150 | mA | Continuous output current |
| Shutdown Current | Isd | - | 0.1 | 1.0 | μA | Quiescent current in shutdown mode |
| Enable Input Voltage | Ven | 1.2 | - | - | V | Minimum enable voltage |
| Output Voltage | Vout | - | 3.3 | - | V | Regulated output voltage (fixed) |
| Line Regulation | ΔVout/ΔVin | - | 0.01 | 0.05 | %/V | Change in output voltage with respect to input voltage |
| Load Regulation | ΔVout/ΔIout | - | 0.05 | 0.1 | %/mA | Change in output voltage with respect to load current |
| Dropout Voltage | Vdo | - | 250 | 350 | mV | Voltage difference between input and output at full load |
| Operating Temperature Range | Toper | -40 | - | 85 | °C | Ambient temperature range for operation |
| Storage Temperature Range | Tstg | -65 | - | 150 | °C | Temperature range for storage |
Instructions:
Power Supply Connection:
- Connect the Vcc pin to the input power supply within the specified operating voltage range (2.7V to 5.5V).
- Ensure a stable and clean power supply to avoid voltage drops or spikes.
Output Configuration:
- The output voltage (Vout) is fixed at 3.3V. No external resistors are required for voltage setting.
- Connect the output pin (Vout) to the load or circuit requiring regulated 3.3V.
Enable Pin:
- The enable pin (EN) can be used to control the operation of the regulator.
- Apply a voltage greater than 1.2V to the EN pin to activate the regulator.
- Pull the EN pin to ground or leave it floating to put the regulator into shutdown mode, reducing quiescent current to less than 1.0 μA.
Capacitors:
- Use a 1 μF ceramic capacitor on the input side (Vcc) and a 1 μF ceramic capacitor on the output side (Vout) for stability and noise reduction.
- Place these capacitors as close as possible to the respective pins to minimize parasitic inductance.
Thermal Considerations:
- Ensure adequate heat dissipation if the regulator is operating at high currents or in high ambient temperatures.
- The maximum junction temperature should not exceed 125°C.
Layout Guidelines:
- Keep the layout compact and use wide traces for power lines to reduce resistance and inductance.
- Avoid long traces between the input and output capacitors and the regulator pins.
Storage and Handling:
- Store the device in a dry environment within the specified storage temperature range (-65°C to 150°C).
- Handle the device with care to avoid damage from electrostatic discharge (ESD).
Safety Precautions:
- Do not exceed the maximum ratings specified in the parameter table to prevent damage to the device.
- Ensure proper grounding and isolation to avoid electrical hazards.
Inquiry - AP431VL-A
