Share:
Specifications
SKU: 11212794
| Parameter | Symbol | Conditions | Min | Typ | Max | Unit |
|---|---|---|---|---|---|---|
| Supply Voltage | VDD | Operating | 2.0 | 3.3 | 5.5 | V |
| Standby Current | ISB | VDD = 3.3V, All pins Hi-Z | - | 0.1 | 1 | μA |
| Operating Current | IOP | VDD = 3.3V, Active | - | 3 | 6 | mA |
| Output Voltage | VOUT | No Load | 2.0 | 3.3 | 5.5 | V |
| Output Current | IOUT | Continuous | - | 100 | 200 | mA |
| Output Ripple Voltage | VRIPL | 1kHz, 100mA load | - | 30 | 50 | mVp-p |
| Shutdown Voltage | VSHDN | Shutdown pin Hi | 1.8 | 2.2 | 2.6 | V |
| Enable Voltage | VEN | Enable pin Hi | 1.8 | 2.2 | 2.6 | V |
| Thermal Shutdown | TSD | - | - | 150 | - | °C |
| Storage Temperature | TSTG | - | -40 | - | 85 | °C |
Instructions for Use
Power Supply:
- Connect the VDD pin to the power supply, ensuring it is within the range of 2.0V to 5.5V.
- The GND pin must be connected to the ground.
Enable/Shutdown:
- To enable the device, apply a voltage greater than 1.8V to the EN pin.
- To shut down the device, apply a voltage greater than 1.8V to the SHDN pin.
Output Configuration:
- The output voltage (VOUT) can be adjusted by connecting appropriate external components (e.g., resistors, capacitors).
- Ensure the output current does not exceed 200mA continuously.
Thermal Management:
- Monitor the operating temperature to avoid exceeding 150°C, which could trigger thermal shutdown.
- Use adequate heatsinking if necessary.
Storage:
- Store the device in an environment with temperatures between -40°C and 85°C.
Ripple and Noise:
- To minimize output ripple, use a low ESR capacitor on the output.
- Ensure the load current does not cause excessive ripple, which should be within 30mVp-p to 50mVp-p at 1kHz.
Standby Mode:
- When the device is in standby mode, the current consumption is minimized to 0.1μA to 1μA.
Handling:
- Handle the device with care to avoid static damage.
- Follow standard ESD protection guidelines during handling and assembly.
Inquiry - HT82V739
