Instructions for Use

1. Power Supply:

   • Connect VCC to a stable power supply between 2.7V and 5.25V.
   • Connect GND to the ground reference.

2. USB Connection:

   • Connect the USB D+ and D- lines to the corresponding pins on the FT230XS.
   • Ensure proper USB cable and connector are used for reliable communication.

3. UART Configuration:

   • Connect the UART TXD and RXD lines to the respective pins on the FT230XS.
   • Configure the UART settings (baud rate, data bits, parity, stop bits) as required by your application.

4. Control Lines:

   • Connect the control lines (CTS, RTS, DTR, DSR, DCD, RI) if needed for flow control or other functions.
   • These lines can be used to manage handshaking and device state.

5. Firmware and Drivers:

   • Install the appropriate drivers for your operating system to ensure the FT230XS is recognized and functional.
   • Use the FTDI VCP (Virtual COM Port) driver for serial communication.

6. Programming:

   • Use standard UART programming techniques to send and receive data over the serial interface.
   • Refer to the FTDI documentation for specific commands and protocols.

7. Power Management:

   • The FT230XS supports suspend mode to reduce power consumption.
   • Use the wake-up feature via DTR or RTS to resume operation from suspend mode.

8. ESD Protection:

   • Handle the FT230XS with care to avoid ESD damage.
   • Use anti-static wrist straps and mats when handling the device.

9. Testing:

   • Test the connection and communication using a terminal program or custom software.
   • Verify that the device is properly enumerated and that data transmission is error-free.

10. Documentation:

    • Refer to the FT230XS datasheet and application notes for detailed technical information and advanced usage.