Instructions for Use:

1. Forward Voltage (V_F):

   • Ensure the forward voltage does not exceed 1.5V when operating at 20mA to avoid damage.

2. Peak Reverse Voltage (V_RRM):

   • The device can withstand up to 5000V reverse voltage. Ensure the reverse voltage is kept within this limit to prevent breakdown.

3. Continuous Forward Current (I_F):

   • The continuous forward current should not exceed 50mA to ensure reliable operation.

4. Peak Forward Current (I_F(surge)):

   • The peak forward current should be limited to 100mA for pulses of 1ms duration to avoid overheating.

5. Output Collector-Emitter Voltage (V<subCEO):

   • The maximum collector-emitter voltage is 30V. Exceeding this value can cause damage to the output transistor.

6. Output Collector Current (I_C):

   • The continuous collector current should not exceed 30mA to ensure safe operation.

7. Output Turn-On and Turn-Off Times (t_on, t_off):

   • The turn-on and turn-off times are typically 2μs and can extend to 5μs. Design circuits with these timing parameters in mind.

8. Isolation Voltage (V_IORM):

   • The isolation voltage is 5000V_rms for 1 minute at 50/60Hz. Ensure proper insulation and spacing to maintain this isolation.

9. Storage and Operating Temperature Ranges (T_STG, T_A):

   • Store the device between -40°C and 110°C.
   • Operate the device between -40°C and 85°C to ensure reliable performance.

Additional Notes:

• Always refer to the datasheet for the most accurate and detailed information.
• Ensure proper heat dissipation if operating at high currents or temperatures.
• Use appropriate decoupling capacitors and transient protection devices as needed.