Instructions for Use:

1. Power Supply:

   • Ensure the supply voltage (VDD) is within the range of 3.0V to 5.5V.
   • Connect the VDD pin to a stable power source and the GND pin to ground.

2. Signal Levels:

   • The input high voltage (VIH) should be at least 2.0V and can go up to 5.5V.
   • The input low voltage (VIL) should be no more than 0.8V.
   • The output high voltage (VOH) will be at least 2.4V and can go up to 5.0V.
   • The output low voltage (VOL) will be no more than 0.4V.

3. Data Transmission:

   • The device supports data rates up to 150 Mbps.
   • The propagation delay time (tPD) is typically 12 ns.
   • The skew (tSKEW) between differential pairs is typically 2 ns.

4. Temperature Considerations:

   • The operating temperature range is from -40°C to 85°C.
   • The storage temperature range is from -65°C to 150°C.

5. Power Consumption:

   • The typical supply current for the receiver (IDD(R)) is 16 μA.
   • The typical supply current for the driver (IDD(D)) is 400 μA.

6. Handling and Storage:

   • Handle the device with care to avoid damage from electrostatic discharge (ESD).
   • Store the device in a dry, cool environment within the specified storage temperature range.

7. Mounting and Soldering:

   • Follow standard surface mount technology (SMT) procedures for mounting and soldering.
   • Ensure that the soldering temperature does not exceed the maximum storage temperature.

8. Testing and Verification:

   • After assembly, verify the correct operation of the device by testing its input and output signal levels and data transmission performance.

For detailed application notes and further information, refer to the datasheet provided by Analog Devices.