Share:
Specifications
SKU: 11254449
| Parameter | Symbol | Min | Typical | Max | Unit | Conditions |
|---|---|---|---|---|---|---|
| Drain-Source Voltage | VDS | - | - | 200 | V | - |
| Gate-Source Voltage | VGS | -15 | - | 15 | V | - |
| Continuous Drain Current | ID | - | 7 | - | A | TC = 25°C |
| Continuous Drain Current | ID | - | 4.2 | - | A | TC = 100°C |
| Pulse Drain Current | ID(p) | - | 35 | - | A | tp = 10 μs, IG = 5 A |
| Gate Charge | QG | - | 68 | - | nC | - |
| Input Capacitance | Ciss | - | 1950 | - | pF | VDS = 15 V, f = 1 MHz |
| Output Capacitance | Coss | - | 550 | - | pF | VDS = 15 V, f = 1 MHz |
| Reverse Transfer Capacitance | Crss | - | 180 | - | pF | VDS = 15 V, f = 1 MHz |
| On-State Resistance | RDS(on) | - | 0.18 | - | Ω | VGS = 10 V, ID = 7 A |
| Threshold Voltage | VGS(th) | 2 | 4 | 6 | V | ID = 250 μA |
| Total Power Dissipation | PTOT | - | 150 | - | W | TC = 25°C |
| Junction Temperature | TJ | - | - | 175 | °C | - |
| Storage Temperature | TSTG | -55 | - | 150 | °C | - |
Instructions for Use:
Handling Precautions:
- The FQD7P20TM is sensitive to electrostatic discharge (ESD). Handle with care and use proper ESD protection.
- Avoid exposing the device to temperatures outside its specified operating range.
Mounting and Soldering:
- Ensure that the mounting surface is clean and free of contaminants.
- Use a controlled soldering process to avoid overheating the device. The maximum soldering temperature should not exceed 260°C for more than 10 seconds.
- Allow the device to cool naturally after soldering to prevent thermal shock.
Electrical Connections:
- Connect the drain (D), source (S), and gate (G) terminals according to the circuit diagram.
- Ensure that the gate-source voltage (VGS) does not exceed the maximum rating of ±15V.
- Use appropriate decoupling capacitors to stabilize the power supply and reduce noise.
Thermal Management:
- The device can dissipate up to 150W of power at a case temperature of 25°C. For higher power applications, ensure adequate heat sinking to keep the junction temperature below 175°C.
- Monitor the device temperature during operation to prevent thermal runaway.
Testing and Troubleshooting:
- Before applying power, verify all connections and ensure that the circuit is correctly configured.
- Use a multimeter to check for continuity and correct voltage levels at the terminals.
- If the device fails to operate as expected, check for overvoltage, overcurrent, or thermal issues.
Storage:
- Store the device in a dry, cool environment to prevent moisture damage.
- Keep the device in its original packaging until ready for use to protect against static and physical damage.
By following these guidelines, you can ensure optimal performance and reliability of the FQD7P20TM in your application.
(For reference only)Inquiry - FQD7P20TM
