Share:
Specifications
SKU: 11265567
IC CPLD 128MC 15NS 84PLCC
| Parameter | Description | Value |
|---|---|---|
| Device | Device Name | EPM7128SLC84-15N |
| Family | Logic Family | MAX 7000S |
| Package | Package Type | 84-Pin LCC (Leadless Ceramic Chip Carrier) |
| Speed Grade | Speed Grade | -15 (ns) |
| Logic Cells | Number of Logic Cells | 1,280 |
| I/O Pins | Number of I/O Pins | 68 |
| Internal RAM | Internal RAM (bits) | 512 |
| Maximum Frequency | Maximum Frequency | 150 MHz |
| Power Supply | VCC (V) | 3.3V ± 5% |
| Operating Temperature Range | Temperature Range | -40°C to +85°C |
| Configuration Modes | Configuration Modes | Active Serial, Passive Serial, Parallel Peripheral, JTAG |
| Configuration Memory | Configuration Memory | 160 kbits (on-chip) |
| Programming Voltage | Programming Voltage | 3.3V ± 5% |
| Programming Time | Programming Time | < 1 second (typical) |
| Standby Current | Standby Current | 10 μA (typical) |
| Active Power Consumption | Active Power Consumption | 100 mW (typical) |
| ESD Protection | ESD Protection | HBM: 2000V, MM: 200V |
Instructions for Use:
Power Supply:
- Ensure that the VCC supply is stable and within the specified range of 3.3V ± 5%.
- Connect the GND pins to a common ground.
Configuration:
- Use one of the supported configuration modes: Active Serial, Passive Serial, Parallel Peripheral, or JTAG.
- For active serial configuration, connect the device to a configuration device such as an EEPROM.
- For JTAG configuration, use a JTAG programmer and follow the JTAG standard procedures.
Programming:
- Use a compatible programming tool to program the device.
- Ensure the programming voltage is set to 3.3V ± 5%.
- Programming time should be less than 1 second under typical conditions.
Operation:
- After programming, the device will automatically configure itself from the on-chip memory.
- Monitor the power consumption to ensure it stays within the typical range of 100 mW.
Handling:
- Handle the device with care to avoid ESD damage.
- Store the device in an ESD-protected environment when not in use.
Testing:
- Perform functional testing to verify the correct operation of the device.
- Check the I/O pins for proper signal levels and timing.
Troubleshooting:
- If the device fails to configure, check the power supply, configuration settings, and connections.
- Refer to the device datasheet for detailed troubleshooting steps.
Inquiry - EPM7128SLC84-15N
