Instructions for Use

1. Power Supply:

   • Connect V_CC to the power supply voltage within the range of 2.0V to 6.0V.
   • Connect GND to the ground.

2. Data Input:

   • Connect the data input pin (DS) to the source of serial data.
   • Ensure that the input voltage levels (V_IH and V_IL) are within the specified range.

3. Shift Register Clock:

   • Connect the shift register clock pin (SH_CP) to the clock signal source.
   • The rising edge of SH_CP shifts the data into the register.

4. Storage Register Clock:

   • Connect the storage register clock pin (ST_CP) to the clock signal source.
   • The rising edge of ST_CP transfers the data from the shift register to the storage register.

5. Output Enable:

   • Connect the output enable pin (OE) to control the output state.
   • Active low: When OE is low, the outputs are enabled.
   • High impedance: When OE is high, the outputs are in a high-impedance state.

6. Master Reset:

   • Connect the master reset pin (MR) to control the reset function.
   • Active low: When MR is low, all registers are cleared and the outputs are set to high impedance.

7. Output Pins:

   • Connect the output pins (Q0 to Q7) to the desired load.
   • Ensure that the current through each output does not exceed 35 mA and the total package current does not exceed 100 mA.

8. Temperature Considerations:

   • Ensure that the operating temperature is within the range of -40°C to 85°C.
   • Store the device in an environment where the temperature does not exceed -65°C to 150°C.

9. Handling Precautions:

   • Handle the device with care to avoid static damage.
   • Follow proper soldering techniques to ensure reliable connections.

10. Testing and Verification:

    • Verify the functionality of the device by testing the input and output signals under typical operating conditions.