Instructions:

1. Handling:

   • Handle with care to avoid mechanical shock or damage.
   • Use proper ESD (Electrostatic Discharge) protection when handling the component.

2. Soldering:

   • Use a soldering iron with a temperature not exceeding 300°C.
   • Ensure that the soldering process is completed within 10 seconds per pad.
   • Allow the component to cool naturally after soldering.

3. Power Supply:

   • Connect the supply voltage (3.3V ± 0.3V) to the designated pins.
   • Ensure a stable power supply to maintain frequency accuracy.

4. PCB Layout:

   • Place the oscillator as close as possible to the load circuit to minimize signal loss.
   • Use ground planes to reduce noise and improve stability.

5. Testing:

   • After installation, verify the frequency output using a frequency counter or spectrum analyzer.
   • Check for any signs of overheating or instability during operation.

6. Storage:

   • Store in a dry, cool place away from direct sunlight.
   • Avoid exposure to high humidity and extreme temperatures.

7. Troubleshooting:

   • If the oscillator does not start, check the power supply connections and ensure there are no shorts.
   • If the frequency is out of tolerance, verify the supply voltage and operating temperature.