Instructions for Use

1. Mounting:

   • Ensure the PCB is clean and free from contaminants.
   • Place the YMU787B-CZE7 on the designated footprint with the correct orientation.
   • Apply a small amount of solder paste to the pads.
   • Use a reflow soldering process with a suitable temperature profile to ensure proper bonding.

2. Power Supply:

   • Connect the supply voltage (1.8V to 3.3V) to the Vcc pin and ground to the GND pin.
   • Use decoupling capacitors (typically 0.1 μF) close to the power pins to filter out noise.

3. Signal Connections:

   • Connect the output signal to the appropriate input of your circuit.
   • Ensure the load capacitance is within the specified range to maintain accuracy.

4. Handling:

   • Handle the component with care to avoid mechanical stress.
   • Use ESD-safe tools and practices to prevent damage from static electricity.

5. Testing:

   • After assembly, verify the frequency output using a frequency counter or oscilloscope.
   • Check for any shorts or open circuits on the PCB.

6. Storage:

   • Store the component in a dry, cool place away from direct sunlight.
   • Use anti-static bags for long-term storage to protect against ESD.

For more detailed information, refer to the datasheet provided by the manufacturer.