Instructions for Using G23N60UF

1. Input Voltage (VIN):

   • Ensure the input voltage is within the range of 4.5V to 60V.
   • Avoid exceeding the maximum input voltage to prevent damage.

2. Output Voltage (VOUT):

   • The output voltage is fixed at 5V. No external resistors are needed for adjustment.

3. Output Current (IOUT):

   • The regulator can provide up to 1.2A of output current.
   • Ensure the load does not exceed this limit to avoid overheating or damage.

4. Quiescent Current (IQ):

   • The quiescent current is typically 0.1mA. This is the current consumed by the regulator when no load is present.

5. Efficiency (η):

   • The typical efficiency is 90%. Ensure proper heat dissipation for high current applications.

6. Dropout Voltage (VDROPOUT):

   • The dropout voltage is typically 0.3V. The input voltage should be at least 0.3V higher than the output voltage to maintain regulation.

7. Operating Temperature (TOPR):

   • The operating temperature range is from -40°C to 85°C. Ensure the regulator is used within this range to avoid performance degradation or failure.

8. Storage Temperature (TSTG):

   • The storage temperature range is from -40°C to 125°C. Store the regulator in a dry place to prevent moisture damage.

9. Thermal Resistance (RθJA):

   • The thermal resistance is typically 50°C/W. Use a heatsink if the power dissipation exceeds safe limits.

10. Load Regulation (ΔVOUT/ΔIOUT):

    • The load regulation is typically 0.5%. This indicates the change in output voltage with respect to changes in load current.

11. Line Regulation (ΔVOUT/ΔVIN):

    • The line regulation is typically 0.2%. This indicates the change in output voltage with respect to changes in input voltage.

12. Ripple Rejection (RR):

    • The ripple rejection is typically 70dB at 1kHz. This helps in filtering out noise from the input supply.

13. Start-up Time (tSTART):

    • The start-up time is typically 1ms. This is the time taken for the output voltage to stabilize after power is applied.

14. Short-Circuit Protection (SCP):

    • The regulator has built-in short-circuit protection. It will automatically shut down if a short circuit is detected.

15. Over-Temperature Protection (OTP):

    • The regulator has over-temperature protection. It will shut down if the temperature exceeds safe limits to prevent damage.