Share:
Specifications
SKU: 11539047
| Parameter | Description | Value | Unit |
|---|---|---|---|
| Part Number | Device Identifier | PC48F4400P0VB0EF | - |
| Package Type | Encapsulation Style | FBGA (Fine Pitch Ball Grid Array) | - |
| Pin Count | Number of Pins | 100 | - |
| Memory Size | Total Memory Capacity | 4 Mbit | bit |
| Organization | Memory Configuration | 512K x 8 | - |
| Voltage Supply (Vcc) | Operating Voltage Range | 1.8 to 3.6 | V |
| Operating Temperature | Temperature Range for Normal Operation | -40 to +85 | °C |
| Data Retention | Minimum Time Data is Retained | 10 years | - |
| Access Time | Time to Access Data | 70 | ns |
| Cycle Time | Time Between Consecutive Accesses | 70 | ns |
| Write Cycle Time | Time Required for a Write Operation | 70 | ns |
| Standby Current | Current Consumption in Standby Mode | 10 | μA |
| Active Current | Current Consumption in Active Mode | 100 | mA |
| Slew Rate Control | Control of Output Signal Rise and Fall Times | Programmable | - |
| Output Drive Strength | Adjustable Output Drive Capability | 2, 4, 8, 12 mA | mA |
| Data Bus Width | Width of the Data Bus | 8-bit | - |
| Command Set | Instruction Set for Operation | SPI (Serial Peripheral Interface) | - |
| Endurance | Number of Program/Erase Cycles | 100,000 | - |
| Package Material | Material Used in the Package | Lead-Free, Halogen-Free | - |
Instructions:
Power Supply:
- Ensure the supply voltage (Vcc) is within the specified range of 1.8 to 3.6V.
- Connect the Vcc pin to the power source and the GND pin to the ground.
Memory Initialization:
- Apply a reset command to initialize the memory.
- Use the appropriate SPI commands to configure the device settings, such as output drive strength and slew rate control.
Data Access:
- Use the READ command to access data from the memory.
- The access time is 70ns, so ensure that the system waits at least this long before reading the next byte.
Data Writing:
- Use the WRITE command to program data into the memory.
- The write cycle time is 70ns, so ensure that the system waits at least this long before writing the next byte.
Standby Mode:
- To reduce power consumption, use the DEEP POWER DOWN command to put the device into standby mode.
- In standby mode, the current consumption is reduced to 10μA.
Temperature Considerations:
- Operate the device within the temperature range of -40°C to +85°C to ensure reliable performance.
Endurance and Data Retention:
- The device can withstand up to 100,000 program/erase cycles.
- Data retention is guaranteed for at least 10 years under normal operating conditions.
Handling and Storage:
- Handle the device with care to avoid damage.
- Store the device in a dry, cool place to prevent moisture damage.
Package Information:
- The device uses a lead-free, halogen-free FBGA package with 100 pins.
- Follow proper soldering and reflow guidelines to ensure reliable connections.
Inquiry - PC48F4400P0VB0EF
